| 1. | A . filling weight : 5000grams b . filling speed : 10 45bags minute
充填重量：小于等于5000克 |
| 2. | It can enlarge the injection quantity and improve the filling speed , it applies to almost the all of plastic materials
能扩大注塑量和提高注塑速度，适用于各种塑胶。 |
| 3. | The cross - section area of the internal sprue , the fill speed , the fill time and injection pressure are important die casting technology parameters
摘要内浇道截面积、充填速度、充填时间和压射比压都是重要的压铸工艺参数。 |
| 4. | The cross section area of the internal sprue of the die casting dies designed should be of proper value , and matches perfectly the fill speed , the fill time and injection pressure in case that the die casting dies fail in the design
设计压铸模时应当确定恰当的内浇道截面积，并使之与充填速度、充填时间和压射比压保持较好的匹配，以防止压铸模设计的失败。 |
| 5. | It can make the smallest gate mark thar is used for the best plan with strict surface requirements and good products function . it can enlarge the injection quantity and improve the filling speed , it applies to almost the all of plastic materials
能做到最小胶口痕迹，是应用于严格表面要求达到高产品性能的最佳方案，能扩大注塑量提高注塑速度，适于各种塑胶。 |
| 6. | It is found that different genotypes of maize was markedly different in seed growing and filling speed , the varieties which had lower and steadier rate of average growth and earlier appeared max filling - speed could realize adversity resistance and good harvest
不同基因型之间存在显著差异，籽粒相对生长率低而稳定、最大灌装速度出现早的品种能够抗逆高产。 |
| 7. | Variance index of the settlements of soft clay subgrade was inducted to analyze the asymmetry settlement rules under the influence of depth of fill , fill speed , geologic types of soft clay etc
利用这些观测数据，引入路堤断面中点和两侧坡脚地基表面3点沉降的方差这一统计学指标，详细分析了地质结构，填筑速率、填筑高度以及硬壳层等因素对软基不均匀沉降的影响，得到了一些有意义的结论。 |
| 8. | In this paper , the software for the die casting technology parameters design is built based on the optimization of the die casting system matching , and is used for the design of the die casting technology parameters , such as the cross section area of the internal sprue , the fill speed and the fill time etc
文章基于压铸系统匹配优化的思想，建立压铸工艺设计软件，使用软件进行内浇道截面积、充填速度和充填时间等压铸工艺参数的设计。 |
| 9. | Our aseptic filling equipment includes sterile air - generator , aseptic filling system , and automatic self - clean system which has achieved the international technical standards from the system itself and the filling speed , and its scope of packaging material using is wider than similar foreign equipment
无菌灌装设备主要部分为无菌空气发生系统、无菌灌装系统和自动清洗系统，从系统本身及灌装速度上完全达到了国际上同类产品的技术水平，在使用包装材料的范围上更是超过国外同类设备。 |
